All paint should be used according to the manufacturer’s instructions.
Set up a spray area by covering work area with a drop cloth. Make sure it is a well-ventilated area.
Prep surface by sanding any rough areas. If there are areas with flaking rust, use a wire brush to remove it.
Thoroughly clean the fire pit with an all-purpose cleaner/degreaser. Rinse with water and allow to dry.
Tape off any surfaces that you do not want to paint.
Holding the can of Krylon High Heat - Flat Brown 6-8 inches from the surface, begin painting using a sweeping side-to-side motion with slight overlap.
Allow paint to dry for 30-60 seconds.
Continue to apply light, multiple coats, waiting 30-60 seconds between each, until you are satisfied with the appearance.
NOTE: Do not apply paint to the inside of the fire pit where surface is exposed to open flame.
Krylon High Heat dries to the touch in 10 minutes and can be handled in about one hour.
Allow to dry overnight before using.
Metal makeovers can be easy. Check out these great projects shared by spray paint fans just like you.