Sand all four pieces until surface is smooth, cleaning any dust off afterwards.
After reading the label for safety and application instructions, in a side-to-side motion spray two of the boards entirely with Fusion All-In-One Satin Spring Grass.
Once both pieces have dried thoroughly, add a second coat of Fusion All-In-One Satin Spring Grass. (Please see label for appropriate dry time).
For the second chair, repeat steps 3+4 on the remaining two pieces of plywood using Fusion All-In-One Gloss Sunbeam.
Apply contact paper to the entire surface of one side to each of the boards. Press down firmly to ensure there are no air bubbles.
Draw desired design onto the contact paper using a marker or grease pencil. (For flower design trace circles using a roll of tape).
Cut the traced shapes out using a craft blade or similar tool.
For flower design, spray the center of each circle with Fusion All-In-One Gloss Jungle Green.
While drying, cut out smaller circles from the contact paper which will be the center of the shapes that have been sprayed.
Ensuring that contact paper is pressed down flat, spray onto the stencil of the Satin Spring Grass board with two coats Gloss Sunbeam. Wait for spray paint to dry in between each coat. (Please see label for appropriate dry time).
With the Gloss Sunbeam board repeat step 11 using Satin Spring Grass.
Spray all hinges and screws Gloss Jungle Green and install on the tops of the boards.
Drill a hole the width of your rope approximately two inches from the bottom and in the center of each board.
Cut a rope to about 3 feet and thread through front and back of the board tying a knot on each side (Repeat for second chair).
Cut an excess rope from the front of the board, ensuring the knot stays intact.
Sit back with family and friends to watch your favorite movies. Then collapse chairs until the next time!
Get Inspired To Spray
Wood and spray paint are a great combo. Go big and revive a piece of furniture. Go small and revamp a decorative box.